Synthesis and properties of triethylammonium 2,2,5-triphenyl-1,3,2,5-dioxaborataphosphorinane

The reaction of bis(hydroxymethyl)phenylphosphine with isobutyl diphenylborate in the presence of triethylamine leads to the formation of triethylammonium 2,2,5-triphenyl-1,3,2,5-dioxaborataphosphorinane (1). The reaction of compound 1 with electrophilic reagents (O, S, Se, CH₂O, RHal) leads to quaternization of the phosphorus atom, giving the corresponding phosphine oxides, sulfides, and selenides and P,B-containing betaines. In the reactions of compound 1 with amines aminomethylphosphines of the diazaphosphorinane and diazadiphosphacyclooctane series are formed. Ammonium 1,3,2,5-dioxaborataphosphorinanes dissociate in solutions and enter into ion exchange with phosphonium iodides, leading to phosphonium 1,3,2,5-dioxaborataphosphorinanes. The latter, in the case of the aminomethylphosphonium cation, undergo intramolecular rearrangement with the formation of P,B-containing betaines and aminomethylphosphines.Deceased.A. E. Arbuzov Institute of Organic and Physical Chemistry, Kazan' Scientific Center, Russian Academy of Sciences, 420083 Kazan'. Translated fromIzvestiya Akademii Nauk, Seriya Khimicheskaya, No. 6, pp. 1398–1405, June, 1992.     

纯锆上离子注入钇和镧后的表面分析

用金属蒸汽真空弧源，以40kV加速电压对纯锆样品分别进行了10¹⁶—10¹⁷/cm²的钇、镧离子注入，注入温度约为130℃.然后对注入样品进行表面分析.x射线光电子能谱分析表明，注入的钇以Y₂O₃形式存在，镧以La₂O₃形式存在.俄歇电子能谱表明，纯锆基体表面的氧化膜厚度随着离子注入剂量的增加而增加，当离子注入剂量达到10¹⁷/cm²时，氧化膜的厚度达到了最大值.卢瑟福背散射显示镧层的厚度约为30nm，同时直接观察到当离子注入剂量为(La+Y)10¹⁷/cm²时，纯锆样品表面发生了严重的溅射. 关键词： 纯锆 钇和镧离子共注入 卢瑟福背散射 x射线光电子能谱     

Catalytic Activity of Nickel Alloys in Anodic Oxidation of the Hypophosphite Ion as a Function of Their Composition

The rate of anodic oxidation of the hypophosphite ion on alloys Ni-P, Ni-B, and Ni-Mo-P is studied as a function of their composition and structure. The organic compounds that are customarily used to stabilize electrolytes of electroless nickel plating are shown to come useful when controlling composition of the Ni-P coatings at the expense of their different influence on the rates of partial processes of deposition of the alloy components. The formation of catalytic activity of such coatings is affected mostly by a structural factor. With alloys Ni-P, Ni-B, and Ni-Mo-P, whose composition was varied by altering the concentration of the source of the alloying component, dependence of catalytic activity of the surface on the composition is defined mainly by an electronic factor.__________Translated from Elektrokhimiya, Vol. 41, No. 8, 2005, pp. 972–980.Original Russian Text Copyright © 2005 by Sotskaya, Dolgikh, Ryabinina.     

Ce3+离子敏化Eu3+∶Cr3+∶Sm3+∶YAG外延层的荧光现象

对Ce3+ ∶Eu3+ ∶Cr3+ ∶Sm3+ ∶YAG处延层中的荧光敏化现象进行了报道和分析 ,在较高浓度的Ce3+ 离子掺杂时 ,外延层在蓝色、绿色波段出现了新的荧光谱线 ,可解释为在Ce3+ 离子敏化作用下 ,Eu3+ 离子产生了由高位激发态能级5Di(i=1,2 ,3)直接到基态能级7Fj(j =0 ,1,2 ,3)的辐射跃迁过程 ,并且这种Ce3+ ∶Eu3+ ∶Cr3+ ∶Sm3+ ∶YAG外延层还是一种新颖的白色单晶荧光材料。     

PHOBOS at RHIC: Some global observations

Particle production in Au+Au collisions has been measured in the PHOBOS experiment at RHIC for a range of collision energies for a large span of pseudorapidities, |η| < 5.4. Three empirical observations have emerged from this data set which require theoretical examination. First, there is clear evidence of limiting fragmentation. Namely, particle production in central Au + Au collisions, when expressed as dN/dη′ ( η′ ≡ – y_beam), becomes energy independent at high energy for a broad region of η′ around η′ = 0. This energy-independent region grows with energy, allowing only a limited region (if any) of longitudinal boost-invariance. Second, there is a striking similarity between particle production in e⁺e⁻and Au + Au collisions (scaled by the number of participating nucleon pairs). Both the total number of produced particles and the longitudinal distribution of produced particles are approximately the same in e⁺e⁻and in scaled Au + Au. This observation This presentation is based in large part on the PHOBOS summary talk by M Baker at the16th Int. Conf. on Ultrarelativistic Nucleus- Nucleus Collisions, Quark Matter 2002, Nantes, France was not predicted and has not been explained. Finally, particle production has been found to scale approximately with the number of participating nucleon pairs for (N _part ) > 65. This scaling occurs both for the total multiplicity and for highp _T particles (3 <p _T < 4.5 GeV/c). This presentation is based in large part on the PHOBOS summary talk by M Baker at the16th Int. Conf. on Ultrarelativistic Nucleus-Nucleus Collisions, Quark Matter 2002, Nantes, France     

Synthesis and application as polymer electrolyte of hyperbranched polyether made by cationic ring‐opening polymerization of 3‐{2‐[2‐(2‐hydroxyethoxy)ethoxy]ethoxymethyl}‐3′‐methyl‐oxetane

A novel cyclic ether monomer 3‐{2‐[2‐(2‐hydroxyethoxy)ethoxy]ethoxy‐methyl}‐3′‐methyloxetane (HEMO) was prepared from the reaction of 3‐hydroxymethyl‐3′‐methyloxetane tosylate with triethylene glycol. The corresponding hyperbranched polyether (PHEMO) was synthesized using BF₃·Et₂O as initiator through cationic ring‐opening polymerization. The evidence from ¹H and ¹³C NMR analyses revealed that the hyperbranched structure is constructed by the competition between two chain propagation mechanisms, i.e. active chain end and activated monomer mechanism. The terminal structure of PHEMO with a cyclic fragment was definitely detected by MALDI‐TOF measurement. A DSC test implied that the resulting polyether has excellent segment motion performance potentially beneficial for the ion transport of polymer electrolytes. Moreover, a TGA assay showed that this hyperbranched polymer possesses high thermostability as compared to its liquid counterpart. The ion conductivity was measured to reach 5.6 × 10^?5 S/cm at room temperature and 6.3 × 10^?4 S/cm at 80 °C after doped with LiTFSI at a ratio of Li:O = 0.05, presenting the promise to meet the practical requirement of lithium ion batteries for polymer electrolytes. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 3650–3665, 2006     

Preparation and Characterization of a Cobalt‐Containing Mono‐Phosphine Ligand and its Coordinated Molybdenum Complex

A cobalt‐containing monodentate phosphine [(μ₂‐PPh₂CH₂PPh₂‐κ²P)Co₂(CO)₄][μ₂‐η²‐PhC≡CP(i‐Pr)₂] 2f , was prepared from the reaction of (μ₂‐PPh₂CH₂PPh₂‐κ²P)Co₂(CO)₆ 1 with PhC≡CP(i‐Pr)₂. It was accompanied by an oxidized compound, [(μ₂‐PPh₂CH₂PPh₂‐κ²P)Co₂(CO)₄][μ₂‐η²‐PhC≡CP(=O)(i‐Pr₂)] 2fo during the chromatographic process. Further reaction of 2f with Mo(CO)₆ resulted in the formation of a 2f ‐ligated molybdenum complex 4 , [(μ₂‐PPh₂CH₂PPh₂‐κ²P)Co₂(CO)₄][μ₂‐η²‐PhC≡CP(i‐Pr₂)‐κP]‐Mo(CO)₅.     

Synergistic effect between 4-(2-pyridylazo) resorcin and chloride ion on the corrosion of cold rolled steel in 0.5 M sulfuric acid

The corrosion inhibition of 1-(2-pyridylazo)-2-naphthol (PAR) on the corrosion of cold rolled steel in 0.5 M sulfuric acid (H₂SO₄) was studied using weight loss method and potentiodynamic polarization method. Results obtained revealed that together with chloride ion, PAR is an effective corrosion inhibitor for steel corrosion in sulfuric acid. It was found that for steel corrosion inhibition in the presence of single PAR in sulfuric acid the Temkin adsorption isotherm may be used to explain the adsorption phenomenon. For the mixture of PAR and NaCl used as corrosion inhibitor, however, the Langmuir adsorption isotherm can be used to satisfactorily elucidate the adsorption of mixture of PAR and NaCl. Potentiodynamic polarization studies showed that single PAR mainly acts as a cathodic inhibitor for the corrosion of steel in 0.5 M sulfuric acid. The mixture of PAR and chloride ion, however, acts as a mixed type inhibitor that mainly inhibits cathodic reaction of the steel corrosion in sulfuric acid. By means of electrochemical polarization tests, a desorption potential at ca. −370 mV was observed for the adsorption of mixture of PAR and chloride ion, when potential reaches this value, adsorbed inhibitor molecule heavily departs from the steel surface. For the mixture of PAR and chloride ion, thermodynamic parameters such as adsorption heat, adsorption entropy and adsorption free energy were obtained from experimental data of the temperature studies of the inhibition process at four temperatures ranging from 30 to 45 °C, the kinetic data such as apparent activation energies and pre-exponential factors at different concentrations of the inhibitor were calculated, and the effect of the apparent activation energies and pre-exponential factors on the corrosion rates of cold rolled steel was discussed. The most suitable range of inhibitor concentration was discussed. The inhibitive action was satisfactorily explained by using both thermodynamic and kinetic models. Synergism between chloride ion and PAR was proposed. The results obtained from weight loss and potentiodynamic polarization were in good agreement.     

利用低能质子束产生高强度放射性束流

加拿大TRIUMF实验室利用¹¹C成功验证了一种产生高强度(～10⁸ions/s)放射性束流的方法. 该方法不同于普通在线同位素分离方法, 它利用了13MeV的低能强流质子束, 可以产生一系列核天体物理实验感兴趣的高强度放射性束流.